Server room

We built a server / laser cutter room to contain the noise. Watch us build it in 45 seconds!

Highlights:

  • 04:27:46 PM: My first powder driven nail shot with Thor’s Amazing Wham Hammer (thx, 3ric)
  • 05:50:45-05:53:45 PM: Sponsored by Ryobi
  • 06:22:45 PM: Subliminal technofear
  • 08:31:15 PM: More thunderstick action. Phil takes precautions.
  • 09:11:45 PM: Where’s the level?
  • 09:12:15 PM: Oh, there it is.
  • 09:48:15 PM: Chris’ patented go-go-gadget-go-kart-ladder!
  • 12:16:15 AM: Snack time.

Adventures with Eagle

Thanks to my extremely encouraging dad, I’ve been building circuits since I was seven years old. Freehanding a breakout board with my trusty Weller is second nature. Growing up, I always had a Heathkit or  Radio Shack 200-in-1 kit lying around in various states of assembly and/or modification. I learned to read schematics, and got quite good at physical assembly.

But I somehow never quite made the leap to designing circuits from scratch. Computers (and also girls) were a lot more interesting to me than studying electronics design. Fast forward a couple of decades, and I’ve noticed that years of tweaking other people’s designs and building things from kits gotten me into some bad habits. I have finally reached a point where I want to make circuits that do novel things, and freehanding, while quick and dirty, is not always the best choice for building complex circuits. Especially when high voltages are involved.

So after months of putting it off, I bit the bullet and started digging into CadSoft Eagle. To get going quickly, I worked through Sparkfun’s Eagle tutorial. I must say that after a bit of a shaky start (warning: UI designed by EEs ahoy!) I’m really starting to enjoy it. Draw a schematic, link it to physical components, make your connections, and you’re building real “grown-up” circuit boards! After about a weekend’s worth of effort, I’ve made a header board for the Nixie Tube HV Volt Meter project and a new revision of the Singing Arc. These are two-layer, through-hole boards with many more connections than are practical to run by hand.

Of course I’m excited now, because my designs look perfect (to my biased and poorly schooled eye) and they aren’t yet baked into copper and fiberglass. The real fun (and likely disappointment) will come in a couple of weeks when I get to populate, power up, and debug the boards. I know I still have a lot to learn ahead of me. But this free tool is becoming addictive. Playing the Eagle video game is a lot more fun than most. Sure there’s a lot of grind in the beginning, but by the end you level-up with real electronics…

I’m going to post my designs once I get the boards back, so I can give a full report on my first PCB attempt. Keep your fingers crossed!